Allen-Bradley 2-D Manuel d'utilisateur télécharger pdf (Page 73)

Programming

5-4

PROGRAMMING EXAMPLE

The following is an example of the programming steps required to change a parameter setting. In this example, the parameter

[Freq Select 1] is being programmed from its’ factory default setting of “Adapter 1” to a new setting, “Adapter 2”.

ACTION

DESCRIPTION

HIM DISPLAY

ESC SEL

To Select Mode

To Select a Group

SEL

To Select a Parameter

within a Group

To Change a Parameter

Setting or Enter a Value

❏ 1. Press any key to go from the Status Display to the ‘‘Choose Mode” menu.

❏ 2. Press the Up/Down keys until ‘‘Program” appears on the display.

❏ 3. Press the Enter key to go to the ‘‘Program” menu.

❏ 4. Press the Up/Down keys until “Setup” appears on the display.

❏ 5. Press the Enter key to go to the “Setup” menu.

❏ 6. Press the Up/Down keys until [Freq Select 1] appears on the display.

❏ 7. Press the SEL key. The first character of line 2 will flash indicating the

parameter setting/value can be changed.

❏ 8. Press the Up/Down keys until ‘‘Adapter 2” appears on the display.

❏ 9. Press the Enter key to program [Freq Select 1] to ‘‘Adapter 2.”

Stopped

+0.00 Hz

Choose Mode

Program

Choose Group

Setup

Freq Select 1

Adapter 2

Freq Select 1

Remote Pot

Freq Select 1

Adapter 2

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 171 172

Pas de commentaire

Allen-Bradley 2-D Manuel d'utilisateur Page 73