Allen-Bradley 2-D Manuel d'installation télécharger pdf (Page 13)

4.4.1. Power Cable Termination

Factory supplied motor power cables (MPC-30-25-3 for “C” series systems or

MPC-60-25-3 for “D” series systems) are designed to be terminated at the drive

during installation. A small portion of the cable jacket is removed which exposes

the shield braid. The exposed area must be clamped to the front of the drive chassis

(refer to Figure 4.2.2.2) using the clamp provided as discussed in chapter 3 of the

“Ultra 3000i Intelligent Positioning Drives Installation Manual” manual provided

with the drive.

The motor connection is made to the circular connector of the cable MPC-30-25-3

for “C” series systems or the MPC-60-25-3 for “D” series systems. Ensure the

connector keys are aligned and fully screw the connectors together.

Installation Manual: http://www.ab.com/manuals/gmc/2098-IN003C-EN-P-JUL01.pdf

Figure 4.2.2.2

Motor Power Cable Shield Termination

4.4.2. Position Sensor (Feedback) Connection

Connect the circular connector of the FSC-LA-25 cable to the motor feedback

connector. Connect the HDB15 connector of the cable to the CN2 connector on the

Ultra 3000i drive.

4.4.3. I/O Connections:

The Control Pendant, 24 VDC I/O power, and Motor Temperature Switch are

connected via the 44-pin connector CN1. The system is shipped with the connector

prewired.

AN-0130 13 of 22 Revision B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Viktor 14 May 2024 | 15:54:21

Hello!

Allen-Bradley 2-D Manuel d'installation Page 13