Allen-Bradley 2-D Manuel d'installation télécharger pdf (Page 19)

5.3.1. Description of Pendant:

1. Disable/Enable: In the Disable position the system is disabled from moving

electronically by the drive. When put into the Enable position the drive will find

home initially and will be ready for a commanded sequence.

2. Enable Fault Indicator: Green indicates the system is enabled and ready to

start a sequence. Red indicates a fault has occurred. Off indicates that the

system is not enabled or has no power.

3. Home: When pressed present sequence will stop and return the motor home

and ready to begin another sequence.

4. Start: When pressed the sequence selected by the selection switches will begin.

5. Sequence Selection Switch 0: The least significant bit used for sequence

selection. It is a lighted switch. When lit the switch is on.

6. Sequence Selection Switch 1: The second significant bit used for sequence

selection. It is a lighted switch. When lit the switch is on.

7. Sequence Selection Switch 2: The most significant bit used for sequence

selection. It is a lighted switch. When lit the switch is on.

Table 5.3.1

Sequence: SW-2 SW-1 SW-0

0 off off off

1 off off on

2 off on off

3 off on on

4 on off off

5 on off on

6 on on off

7 on on on

Figure 5.3.1

Pendant Switch Layout

AN-0130 19 of 22 Revision B

1 2 ... 14 15 16 17 18 19 20 21 22

Viktor 14 May 2024 | 15:54:21

Hello!

Allen-Bradley 2-D Manuel d'installation Page 19