Allen-Bradley 2-D Manuel d'installation télécharger pdf (Page 14)

4.4.3.1. Pendant Connection:

The Control Pendant is wired to a 44-pin connector for CN1 no additional

connection is needed on the pendant.

4.4.3.2. 24VDC Power:

The drive I/O requires a separate 24 VDC power supply. Connect the 24VDC

power supply to the Pigtail on the 44-pin CN1 connector.

4.4.3.3. Over Temperature Sense Cable:

One end of the Over Temperature Sense cable TSC-01-25 is prewired to the 44-

pin CN1 connector. Connect the other end to the motor Over Temperature Sense

connector on the motor.

4.4.4. Communication Cable Connection:

The communication cable CC-01-10 is connected between CN3 on the drive and

the 9 pin male RS-232 connection on the Host PC.

4.4.5. System AC Power

The systems use 208-240 Vac 50/60 Hz applied to the power terminals of the

drive through a fused properly sized disconnect. Use slow blow fuses to prevent

nuisance trips. Refer to Allen-Bradley Installation Manual pg 1-7 for more

information.

Number Line Number of Fuse

System: Phases: Names: Contacts: Size:

IP-2C Single L1, L2 2 28 amp

IP-2D Three L1, L2, L3 3 30 amp

The DC power supply is a dual voltage power supply capable of operating from

85-265 VAC. It can be connected to a standard 110VAC outlet or 240VAC used

for the drive. Use a separate 1-amp slow blow fuse to protect the power supply.

AC Power should be applied observing all the cautions and safety requirements

typical of any equipment with this level of power. Ensure the system is well

grounded before applying power. The Allen-Bradley Ultra 3000i Installation

Manual (2098-IN003C-EN-P) contains detailed information on interconnection of

the drive and should be referenced. Ensure all relevant electrical codes and

standards are followed in accordance with all local and national codes and laws.

Installation Manual: http://www.ab.com/manuals/gmc/2098-IN003C-EN-P-JUL01.pdf

AN-0130 14 of 22 Revision B

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Viktor 14 May 2024 | 15:54:21

Hello!

Allen-Bradley 2-D Manuel d'installation Page 14